HackFFM-Duino Chime: Unterschied zwischen den Versionen

Aus Hackerspace Ffm
Wechseln zu: Navigation, Suche
Zeile 6: Zeile 6:
 
Since I was designing lots of PCB’s anyway I decided to also realize this one.
 
Since I was designing lots of PCB’s anyway I decided to also realize this one.
 
Another requirement was fast responsiveness. The [[SimpleSDAudio]]-library from [[Benutzer:Tut|Tut]] provides just that. [[Benutzer:Tut|Tut]] helped quite a lot with the circuit design in this project.
 
Another requirement was fast responsiveness. The [[SimpleSDAudio]]-library from [[Benutzer:Tut|Tut]] provides just that. [[Benutzer:Tut|Tut]] helped quite a lot with the circuit design in this project.
 
== Design Files ==
 
  
 
== Features ==
 
== Features ==
Zeile 25: Zeile 23:
  
 
8 Pins are accessible including i²C PINS
 
8 Pins are accessible including i²C PINS
 +
 +
== Design Files ==
  
 
== License ==
 
== License ==
  
 
Licensing CC v4.0 Share-Alike (http://creativecommons.org/licenses/by-sa/4.0/)
 
Licensing CC v4.0 Share-Alike (http://creativecommons.org/licenses/by-sa/4.0/)
 +
 +
I started out with the open log design. Although there is not much left of it, it was some help.
 +
 +
I also used libraries from sparkfun and adafruit.
  
 
[[Kategorie:Projekte]]
 
[[Kategorie:Projekte]]

Version vom 5. September 2014, 21:00 Uhr

HackFFM-Duino Chime alpha version

by: DCEM

Motivation

LeandraChristine needed a small solution for sound in a project. Since I was designing lots of PCB’s anyway I decided to also realize this one. Another requirement was fast responsiveness. The SimpleSDAudio-library from Tut provides just that. Tut helped quite a lot with the circuit design in this project.

Features

The board is carrying:

  • Atmega328
  • MAX9098306 3.7W stereo Class D amplifier
  • SN74LVC2G14 dual Schmitt-Trigger with its own low noise power supply
  • microSD-Card Slot
  • 74LVC1G53DP Analog Switch, to set the gain of the Class D amplifier (3 levels)


The controller itself is running on 3.3V (because of the SD-Card). The supply voltage is 5V.

Choose between 8bit Stereo or 16bit mono Sound.

Board size: 15 x 30mm(0.6 x 1.2 inches)

8 Pins are accessible including i²C PINS

Design Files

License

Licensing CC v4.0 Share-Alike (http://creativecommons.org/licenses/by-sa/4.0/)

I started out with the open log design. Although there is not much left of it, it was some help.

I also used libraries from sparkfun and adafruit.