Änderungen

SAMLAIR Airbrush Chamber

85 Byte hinzugefügt, 21:02, 30. Jul. 2018
7. Attach the metal mesh to the "back" of the square-hole plywood sheet. I simply used some tape to secure it on all sides.
 
[[Datei:Filter_mesh.jpg]]
8. Now you can align the plywood parts and the bottom of the box and screw everything together with the M4 screws, and hexnuts. Dont forget to thread the powersupply wire out first, as well as all wires that will power the LEDs.
 
[[Datei:Samlair_Backview.jpg]]
9. Attaching filters to the mesh is done by holding them on with magnets.
10. To allow for variable light positioning, use the gluepads included with the Ledberg to attach the 30mm washers. You can now position the lights by holding them through the Samla's wall with magnets.
 
[[Datei:Light_side.jpg]]
11. For the turntable, drill a hole big enough for the outer diameter of the ball bearing into the center of the Ikea Oleby board and an
118
Bearbeitungen